This article describes how to configure HID Aero controller connection to CredoID software.

Supported devices: X1100, X100, X200, X300

Before use!

Set the battery jumper
1. If attached, unscrew the four corner casing screws.
2. Remove the X1100 cover to access the battery
jumper and the end of line termination jumpers.
3. Set the battery jumper J4 to ON.

Step-by-step guide

  1. Connect an Ethernet cable to the controller and enable controllers default settings, by turning ON switch '2' in DIP switches.
  2. Open web browser and connect to controller over IP address: 192.168.0.251
  3. Note: use Firefox browser to avoid certificate validation errors.



  4. Turn on switch "1" to enable default login details:
    Username: admin
    Password: password
  5. At "Network" tab configure IP address of the device.
  6. At "Host Comm"  set connection type to "IP Client".
  7. "Host IP" to machine address, where CredoID service is running. Set "Connection Mode" to "Continuous".
  8. Data Security: TLS Required.
  9. Port number: 3002
  10. Press "Accept" and then "Apply Settings". Set all switches to OFF.




Write a comment...